SINGER SES1000 FUTURA - Manual (Page 92)


Under side
Côté de dessous
Reverso
Decrease tension
Diminuer la tension
Disminuir tensión
Increase tension
Augmenter la tension
Aumentar tensión
Top side
Côté de dessus
Cara
1
3
2
Foot release button
Presser foot lifter
Palanca pie prensatelas
Foot holder
Support du pied
Sujetador prensatelas
Well balanced
Correct
Bien equilibrada
Levier de verrouillage
du pied
Palanca de desprendimiento
prensatelas
Levier de verrouillage du pied
Top stitch too tight
Fil supérieur trop tendu
Puntada superior
demasiado apretada
Puntada superior
demasiado floja
Top stitch too loose
Fil supérieur trop lâche
ADJUSTING TOP THREAD TENSION
STRAIGHT STITCHING
The correct appearance of your stitching is largely determined
by the balanced tension of both top and bobbin threads. The
tension is well balanced when these two threads ‘lock’ in the
middle of layers of fabric you are sewing.
If, when you start to sew, you find that the stitching is irregular,
you will need to adjust the tension control.
Make any adjustments with presser foot ‘down’.
BOBBIN TENSION
The bobbin tension has been correctly set at the factory, so
you do not need to adjust it.
CHANGING PRESSER FOOT
Be sure the needle is in the highest position. Raise presser
foot lifter.
1. Push presser foot release button to remove the foot.
2. Place the desired foot on the needle plate aligning the
presser foot pin with the foot holder.
3. Lower the presser foot lifter so that the foot holder snaps
on the foot.