Leica Geosystems TPS1100 Professional Series - Applikation - Feldhandbuch (Teil 1) - Manual (Page 30)

30 Stakeout
Stakeout is used to place marks in the field at predetermined
points.
Different stakeout modes are available: polar, orthogonal, auxiliary
points, or grid coordinates. Depending on the active stakeout
mode, the corresponding stakeout elements of the measured point
are calculated in relation to the point to be staked.
Changing to a different stakeout mode is possible at anytime.
Coarse stakeout is an optional step for approximate positioning
preceeding the iterative stakeout process. It may be used to direct
the rod person from the point that has just been staked to the next
point.
The points to be staked can be defined in two ways:
• The coordinates of the point are known. In this case, the points
may be in data or entered manually within the stakeout program.
• The azimuth and horizontal distance to the point are known.
Before starting Stakeout:
The station must be set up and oriented.
Introduction
Basic procedure
1
100pr06
Point to
be staked
Measured
Point
Stakeout
elements