Using the resume function to restart piay, Press [►] while the message is on the tv, Disc selection – Panasonic SC-DK2 User Manual

Page 16: Do not, To prevent damage

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

C5ZJ

RESUME

J

TUNEn'IME ADJ^'

TUHEH'IMEADJ/^^

Discs

Using the resume function to restart piay

If you press [B] during play, the unit remembers the
position.

This function does not work if the disc’s play time is not displayed.

^ To restart piay from the point

Press [>] while “RESUME” is lit.
Remote control: Press

[►/A],

m To review the chapters up to the point where
you stopped play only)

The message “Press PLAY to Chapter Preview” (“Press PLAY to

Chapter Review" for the Australia and New Zealand) appears for a

few seconds before the resume function is activated after pressing

[►].

Press [►] while the message is on the TV.
Remote control: Press

[►/A].

The beginning portions of each chapter up to the current one are

played.

Full play resumes from the point where you stopped play,

Q To cancel the resume function

Press [B] while “RESUME” is lit.

The position is saved even if the unit is turned off.

Resume is canceled if the disc tray is opened or if you change

discs.
Chapter preview is not possible with some DVDs.

r

TUNE MODE

®

RQT5327

®

Disc selection

Choose discs with these marks:

V I D E O

nCOMPftCT

m M M

iDtGITALVIDE^

COMRACT

iE

DIGITAL AUDIO

Do not;

• use irregularly shaped discs (®).

• attach extra labels and stickers.
• use discs with labels and stickers that are coming off or with adhe­

sive exuding from under labels and stickers (©)■

• attach scratch-proof covers or any other kind of accessory.
• write anything on the disc.
• clean discs with liquids. (Wipe with a soft, dry cloth.)
• use discs printed with label printers available on the market

To prevent damage

Always observe the following points.
• Load only 1 disc per tray (©).

• Load discs as shown in figure

An adaptor is not needed with 8 cm discs (singles).

• Set the system on a flat, level surface.
® Always unload all discs before moving the unit.

Do not;

• set the unit on top of magazines, inclined surfaces, etc.
• move the unit while a tray is opening/ciosing, or when loaded.
• put anything except discs in trays.
• use cleaning discs or discs which are badly warped or cracked.

Advertising