Panasonic SC-DK2 - Manual (Page 9)

Optiona! antenna
connections
Before connection
® Do not connect the AC power supply cord until all other con­
nections are complete.
* To prepare the AM loop antenna, speaker cables and FM
antenna, twist the vinyl tip and pull off.
v'
X
1
2
FM antenna.
Fix the other end of the antenna where reception is best.
AM loop antenna.
Clamp the antenna into the antenna holder, then connect the
antenna terminal.
. .
Keep loose antenna cord away from other wires and cords.
Front (L/R) speaker cables.
Connect the cables to the terminals of the same color.
• To prevent damage to circuitry, never short-circuit positive
(+) and negative {-) speaker wires.
• Be sure to connect only positive (red, blue or gray) wires to
positive (+) terminais and negative (black) wires to negative
(-) terminals.
4 Center speaker cable
5 Surround speaker cables
6 TV (not Included)
Connect the video connection cord from this unit to your TV.
Alternatively, connect through the [S-VIDEO] terminal if the
TV has an S-VIDEO terminal (<^ page 52).
T
(Except for U.S.A., Australia and New Zealand)
Set the voltage.
Use a flat-head screwdriver to turn the voltage selector. Set it
to the position for your area.
If the power supply in your area is 115 V or 120 V, please set
the voltage selector as follows
ForllSV: SetiollOV.
For 120 V: Set to 127 V.
8 AC power supply cord.
The shape of the connector depends on the area.
(Except for U.S.A., Australia, New Zealand and Asia)
Q If the power plug will not fit your socket, use the power plug
adaptor (included).
The included AC power supply cord is for use with this unit only. Do
not use it with other equipment.
For your reference
Information you enter into the unit’s memory, except for time,
remains intact for up to a week after the AC power supply cord is
disconnected.
Use outdoor antennas if radio reception is poor,
® Disconnect the FM indoor antenna.
® The antenna should be installed by a competent technician.
Run a piece of vinyl wire horizontally across a window or other con­
venient location.
• Leave the loop antenna connected.
• Disconnect the antenna when the unit is not in use. Do not use the
antenna during an electrical storm.
AM outdoor antenna
RQT5327