Panasonic SC-DK2 - Manual (Page 42)

0 1
TAPE
DECK 172
VTUMEmWIE ADJ
V
i
TUNEmME ADJ/\
Sel^ted direction
r
TUNE MODE
Before recording
(Deck 2 only)
Selection of tapes for recording
The unit automaticaliy identifies the type of tape.
Normal position/TYPE I ✓
High position/TYPE II ✓
Metal position/TYPE IV X
Meta) position tapes can be used, but the unit will not be able to
record or erase them correctly.
Erasure prevention
The illustration shows how to remove the tabs to prevent recording.
To record on the tape again, cover as shown, being careful not to
cover the high position discrimination hole.
Volume, sound quality and surround effects
• Recording level is set automatically.
« Multi-channel sources (3 to 5.1 channels) are automatically down-
mixed to 2 channels during recording.
• All sound effects are automatically set to flat.
Erasing recordings
Preparation;
(Except for U.S.A., Australia and New Zealand)
Disconnect the microphones,
® Press [TAPE, DECK1/2].
@ Insert the recorded tape Into deck 2.
(I) Press [REV MODE] to select the reverse mode.
(4) Press [®REC/STOPj.
Preparatory steps
Recording is done on deck 2. Do not open deck 1 during recording.
Do these steps before each recording.
Wind up the leader tape so recording can begin immediately.
Preparation: Press [0/1, POWER] to turn the unit on.
1
2
Press [ ± DECK 2 OPEN] and insert
the cassette to be recorded on.
Insert with the tape facing down.
Press [REV MODE]
reverse mode.
Each time you press the button:
to select the
* : One side only records.
and : Both sides record (forward reverse).
“ CZ5 ” automatically changes to “ *5 ” when [•REC/STOP]
or [TAPE EDIT] is pressed.
Set the tape direction.
® Press [TAPE, DECK 1/2] to select tape.
(2) Press M/ll] (<) or [►] 0>) to select the direction,
then [H].
=IQT5327