Panasonic SC-DK2 - Manual (Page 31)

1
TAPE
DECK 1/2
)» ( n T n n r
M( u t 11 ) L_
REV MODE
. : j ¡>\
Cassette tapes
You can use either deck 1 or deck 2 for tape playback.
Press [TAPE, DECK 1/2] to select tape
as the source.
The unit comes on automatically.
1
2
Press [± DECK 1 OPEN] or [± DECK 2
OPEN] and insert the cassette.
insert the cassette with exposed tape facing down and close
the holder by hand.
Press [REV MODE] to select the
reverse mode.
Every time you press the button:
T... .T
4
5
^ : One side is played.
: Both sides are played.
c:is: Both sides are played 8 times each.
Press H/ii]
(reverse side) Of [►] (forward side) tO
start play.
Adjust the volume.
To stop the tape
Press [B].
O To change the deck to be used
Press [TAPE, DECK 1/2] to select the deck you want to play.
To listen to 2 tapes consecutively
Insert a tape into each deck and select" " in step 3. Both tapes
will be played 8 times each.
Play is interrupted while playing a tape if you open the other deck.
<0
I
?
II
i2
^/§g
S/TUNE/TIMEADJ ^
y
TUNE/TIME ADJ^
Deck in use
"nb-'r.-L-:'■■■(
jj L L. I • . (
®iiu ■ ■ ■
L-.P-i.......
Tape direction
Cassette tape selection and care
The unit can correctly play the following types. It identifies the type
automaticaily.
Normal position/TYPE 1 ✓
High position/TYPE II ✓
Metal position/TYPE IV ✓
8 Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
® Tape slack can get caught up in the mechanism and should be
wound up before the tape is played.
• Endless tapes can get caught up in the deck’s moving parts if used
incorrectly. Us© tapes appropriate to this unit’s auto-reverse mech­
anism.
TAPE
DECK 1/2
T\ C U D
JJ l_ (_ Í '
fSjll l2i
RQT5327