Cub Cadet 8404 - Manual (Page 102)

CHAPTER 3 8354/8404
3-14 D615-W02 May-2003
615W328A
615W327A
615W326A
C. MAINTENANCE
a . Check of Play Between Clutch Disc Spline
Boss and Gear Shaft
1. Attach gear shaft with clutch disc.
2. With the gear shaft locked, rotate the disc slightly
and measure the play at O.D. end of disc.
3. If the measured value exceeds the allowable limit,
replace the disc.
Sect.
Play at O.D. end of disc
(O.D.: Outside Diameter)
Allowable Limit
2.0 mm
0.079 in.
b. Check of Thrust Ball Bearing
1. Check to see if contacted is worn excessively.
2. With inner wheel seized and outer wheel loaded,
check for abnormal noise or operation.
3. If faulty, replace it.
c. Check of Worn Clutch Disc
1. Using a depth gauge, measure the depth from the
disc to rivet.
2. If the measured value exceeds the allowable limit,
replace it.
Sect.
Depth to upper rivet
from disc (A)
Allowable Limit
0.3 mm
0.012 in.
• When assembling bearing, make sure
the outer wheel is not shocked.
CAUTION