Cub Cadet 8404 - Manual (Page 267)

HYDRAULIC SYSTEM
9-33 D615-W02 May-2003
615W939A
a) Disassembly
1. Before disassembling the top link holder assembly,
disassemble the socket support and coupler socket
assembly.
2. Disassemble bolt (13), lock washer (14), roller (15),
and plate (12).
3. Disassemble nut (21).
4. Remove snap ring (11) and then disassemble pin
(10).
5. Disassemble top link bracket (1).
6. Pull out bolt (7), (9), and then disassemble flange
(2).
7. Disassemble cover (3), spring (4), roller (5), and
bolt (6) in the assembly.
(1) Top Link Holder (12) Plate
(2) Flange (13) Bolt
(3) Cover (14) Lock Washer
(4) Spring (15) Roller
(5) Roller (16) Nut
(6) Bolt (17) Tie Rod
(7) Bolt (18) Snap Ring
(8) Lock Washer (19) Crank
(9) Bolt (20) Pin
(10) Pin (21) Nut
(11) Snap Ring
• Don’t change the assembled position
of plate when disassembling flange
(2).
• Make sure top link holder (1) does not
fall to ground when disassembling pin
(10).
• When assembling bolt (7), check draft
for operation and then repeat assem-
bly several times.
CAUTION
b) Assembly
1. Apply bolt (6), and spring (4) with grease sufficiently
when assembling.
h. Top Link Bracket