Cub Cadet 8404 - Manual (Page 198)

CHAPTER 7 8354/8404
7-10 D615-W02 May-2003
(1) Propulsion Shaft Cover 1
(2) Propulsion Shaft Cover 2
(3) Bolt
(4) Coupling
(5) Spring Pin
(6) Propulsion Shaft 2
(7) O-Ring
(8) O-Ring
(9) O-Ring
615W709A
615W712A
B. Second Stage (Disconnection of Propulsion
Shaft)
1. Loosen propulsion shaft cover 1 (1), propulsion
shaft cover 2 (2) and attaching bolt (3) and tighten
propulsion shaft cover 1 and 2 into inside.
2. Pull out spring pin (5) of coupling (4) and discon-
nect propulsion shaft 2 (6), coupling and propul-
sion cover simultaneously.
(When reassembling)
• Apply propulsion shaft spline and O-ring (7), (8),
and (9) with grease.
(1) Feeding Plug (3) Draining
(2) Oil Level Plug
7.1 DISASSEMBLY, ASSEMBLY
A. First Stage (Front Axle Case Oil Draining)
1. Loosen oil draining plug (1) of front axle support
and front axle case lower section, oil filling plug (3)
and drain oil.
2. Drain oil and retighten plug.
(When supplying with oil)
• Loosen oil filling plug and fill up to the position of
oil level plug.
• Rotate front axle several times and then fill up to the
specified level.
IMPORTANT:
• Always use Cub Cadet Industry approved
front axle oil.
Front axle oil spec. 7.8
7. DISCONNECTION OF FRONT AXLE GROUP