Cub Cadet 8404 - Manual (Page 134)

CHAPTER 4 8354/8404
4-30 D615-W03 May-2003
615W451B
615W449B
(1) Propulsion Shaft Cover
(2) 25 Gear Shaft
(3) Snap Ring
(4) 26 Gear
(5) Oil Seal
10.3 THIRD STAGE (DISASSEMBLY OF 25
GEAR SHAFT AND PROPULSION SHAFT 1)
1. Pull out 25 gear shaft (2) from propulsion shaft
cover (1).
2. Loosen snap ring (3) for shaft and pull out 26
gear (4).
3. Pull out oil seal (5) from clutch housing and
loosen snap ring (6) for hole.
4. Pull out propulsion shaft 1 (7) with bearing.
615W450A
10.4 FOURTH STAGE (DISASSEMBLY OF
BEARING COVER ASSEMBLY)
1. Loosen bearing cover (1) attaching bolt (2) and dis-
connect bearing cover with gears in a body.
(When reassembling)
• Renew oil seal (5), (8), and (9) and apply grease to
the contacted portion of assembly. Make sure di-
rection of assembly is correct.
• When difficult to disconnect bearing
cover assembly, make sure 23 gear
tooth of main shaft gear (3) engaged
with 22 gear shaft (4) tooth, and dis-
connect with gear tooth engaged each
other
CAUTION
(6) Snap Ring
(7) Propulsion Shaft 1
(8) Oil Seal
(9) Oil Seal
(1) Bearing Cover (3) Main Shaft Gear
(2) Bolt (4) 22 Gear Shaft
(When reassembling)
• 26 gear should be assembled with the protruded
gear toward the bearing.