Cub Cadet 8404 - Manual (Page 194)

CHAPTER 7 8354/8404
7-6 D615-W02 May-2003
-
-
-
-
-
-
-
-
-
-
-
0.25 mm
0.098 in.
-
-
0.20 mm
0.0079 in.
-
-
-
-
-
2 ~ 8 mm
0.08 ~ 0.32 in.
1.8 kgf/cm² 25.6 psi
1.6 kgf/cm² 22.8 psi
49.0 ~ 117.6 N
5.0 ~ 12.0 kgf
11.0 ~ 26.5 lbs
7.8
Left: 35° ± 1°
Right: 33° ± 1°
0.15 ~ 0.35 mm
0.059 ~ 0.01377 in.
More than 35 %, center
1/3 ~ 1/2 from small end
0.15 ~ 0.35 mm
0.059 ~ 0.01377 in.
More than 35 %, center
1/3 ~ 1/2 from small end
0.10 ~ 0.30 mm
0.059 ~ 0.01358 in.
More than 35 %, center
1/3 ~ 1/2 from small end
0.16 ~ 0.052 mm
0.00063 ~ 0.00205 in.
16.000 ~ 16.018 mm
0.62992 ~ 0.63063 in.
5.966 ~ 15.984 mm
0.62858 ~ 0.62929 in.
0.050 ~ 0.091 mm
0.00197 ~ 0.00358 in.
32.025 ~ 32.050 mm
1.26083 ~ 1.26181 in.
32.025 ~ 32.050 mm
1.26083 ~ 1.26181 in.
31.959 ~ 31.975 mm
1.25823 ~ 1.25886 in.
0.10 ~ 0.30 mm
0.039 ~ 0.0118 in.
More than 35 %
Tow in (rear width
front width)
7 - 16
8 - 16
Front wheel adjustment
Tire air pressure
Rocking force
Front axle oil spec.
Bi-speed turn operation angle
Bevel gear backlash in front axle case
Bevel gear tooth contacted in bevel gear case
Bevel gear backlash in bevel gear case
Bevel gear tooth contacted in bevel gear case
Backlash of bevel pinion shaft and spiral bevel gear
Tooth contacted between bevel pinion and differential
pinion shaft
Clearance between differential pinion and differential
pinion shaft
Differential pinion I.D.
Differential pinion O.D.
Clearance between front
differential case, differential case cover and differen-
tial side gear
Front differential case I.D.
Differential case cover I.D.
Differential side gear O.D.
Backlash and tooth contacted check of differential
pinion and differential side gear
Tooth contacted check of
differential pinion and differential side gear
Item Reference Value Allowable Limit
NOTE:
• Tire air pressure : Maintain the maximum pressure
in front tires, if using afront loader or when equipped
with a full load of front weights.
4. MAINTENANCE SPECIFICATION