Cub Cadet 8404 - Manual (Page 144)

CHAPTER 4 8354/8404
4-40 D615-W02 May-2003
615W469A
615W468A
615W467A
c. Third Stage (Disassembly of Shuttle Fork)
1. Straighten cocking of lock washer (1) and loosen
lock bolt (2).
2. Pull out fork rod (4) from bearing cover (3) and dis-
assemble transmission fork (5).
(1) Lock Washer (5) Transmission Fork
(2) Lock Bolt (6) Spring
(3) Bearing Cover (7) Ball
(4) Fork Rod (8) Shuttle Transmission Arm
d. Fourth Stage (Disconnection of Gear Shaft
Assembly)
1. Disconnect shuttle shaft assembly (1), 23-21 gear
shaft assembly (2) and 18 gear shaft assembly (3)
from bearing cover (4).
(When reassembling)
• Make sure the assembly position is correct when
assembling gear shaft assembly into bearing cover.
(1) Shuttle Shaft Assembly
(2) 23-21 Gear Shaft Assembly
(3) 18 Gear Shaft Assembly
(4) Bearing Cover
Sect. Spec. Tightening Torque
Tightening bolt M6 9.8 ~ 11.3 N·m
1.0 ~ 1.15 kgf·m
7.2 ~ 8.3 lbf·ft
(When reassembling)
• Insert spring and Ball into bearing cover and as-
semble with groove (A) of fork rod upward.
• Perform cocking of lock washer firmly not to be
loosen after tightened with transmission fork lock
bolt.
• When disassembling fork rod from
bearing cover, take care of Spring (6)
and Ball (7) not to be bounded.
CAUTION