KEYENCE DL-CL1 - Manual (Page 22)

2-6
2
C
onn
ec
tion
a
nd
C
onf
ig
u
ra
ti
o
n
- CC-Link Compatible Network Unit DL-CL1 User’s Manual (FD-S) -
2-2
Wiring
This section describes how to wire the DL-CL1.
• Turn off the power before starting the cabling operation.
• For more information about the CC-Link system, including cable
length and cabling methods, refer to the document of the CC-Link
master unit.
Use the following procedures to connect the DL-CL1 to the CC-Link system.
Usable cables
For connection between the DL-CL1 and the CC-Link system, use CC-Link cables
(Ver. 1.10 or later) accredited by the CC-Link Partner Association.
CC-Link cables (for Ver. 1.10) are available as optional items.
OP-79426 (20 m) OP-79427 (100 m)
To ensure normal communication, only use the CC-Link cables.
Trimming the cable
1
Strip the cable sheath.
Strip approximately 50 mm of the sheath from the end of the CC-Link cable,
with care to avoid damaging the shield braid of the cable.
Point
Connecting to the CC-Link System
Point

Sheath
Shield braid
Approx. 50 mm