KEYENCE LK-G5000 Series - Manual (Page 11)

11
Settings and Procedures
The following settings should be used as a default.
1. Measurement mode and average frequency settings
2. Measuring the amount of eccentricity and vibration
(1) Change the measurement mode for OUT1 to “PEAK-TO-PEAK HOLD” and change the average frequency to 1 time or as
needed.
(1) Click “View Measurement Value”.
(2) Click “Timing” on the input terminal or in the included software to display the amount of eccentricity/vibration whenever
the timing input is ON.
(2) In “General” under “Common Settings”, set the “Sampling cycle” to 20 μs or as needed.
(3) Click “Send settings to controller”. (Pg. 5 of this guide).