KEYENCE LS-Navigator - Manual (Page 48)

5
LS-Navigator-M-NO5-E 5-16
5-7 Setting RS-232C Communication Conditions
For the LS-7000 series
The following steps describe the different methods for checking each of the communication conditions on the
controller
(1) Baud rate
(2) Parity
(3) Stop bit
(4) Data length
Press the [ENT] key on the controller to switch the display
to [BAUDRATE].
Set the same value for [Baud rate] as displayed on the
controller.
Select among 1200, 2400, 4800, 9600, 19200, 36400,
57600, or 115200 from the pull-down menu.
Press the [FUNC] key on the controller to switch the display
to [PARITY].
Set the same value for [Parity] as displayed on the
controller.
Select among NONE, ODD, or EVEN from the pull-down
menu.
Press the [FUNC] key on the controller to switch the display
to [STOPBIT].
Set the same value for [Stop bit] as displayed on the
controller.
Select between 1 and 2 from the pull-down menu.
Press the [FUNC] key on the controller to switch the display
to [D-LENGTH].
Set the same value for [Data length] as displayed on the
controller.
Select between 7 and 8 from the pull-down menu.