KEYENCE LS-Navigator - Manual (Page 57)

5
5-25 LS-Navigator-M-NO5-E
5-10 Setting the Measurement Conditions for the Program
1
Click on the [Output settings] tab in the
program setting area.
The [Output settings] window appears.
2
Various processes are performed on the
values measured from area 1 and area 2,
and these results are output as OUT1 and
OUT2.
Output settings
When the measurement mode is set to
[Self-timing hold] mode, set the self-
timing time.
Parameter range: 1 to 9999 ms
This parameter can only be set during
[Self-timing hold] mode.
1 Calculations are performed using the
measurement values obtained from
measuring the two areas set in [Area
settings].
Select a value from the pull-down menu.
Valid settings:
0, +1, +1/2, -1, -1/2
Set the number of times for averaging from
the pull-down menu.
Set a larger value to average variations in
the measurement value and provide a more
stable result. Set a smaller value to
measure at high speeds.
Valid number of times for averaging:
1, 2, 4, 8, 16, 32, 64, 128, 256, 512, 1024,
2048, 4096
Select the method for output. Some methods
output the raw measurement value, while
others continuously measure a changing
value using a timing and output the maximum
or minimum values. Select the measurement
mode from the pull-down menu. The modes
as divided according to target and conditions
for measurement.
Valid measurement modes:
Normal, peak hold, bottom hold, peak-to-
peak hold, average hold, auto peak hold,
auto bottom hold, auto peak-to-peak hold,
sample hold 1, sample hold 2, self-timing
hold
For more details, see “Measuring Mode”
in the “User’s Manual” for each controller.