Cisco 7200 VXR User Manual
Cisco 7200 vxr routers
Advertising
Quick Start Guide
Cisco 7200 VXR Routers
Connect the Router to the Network
Start and Configure the Router
Advertising
Table of contents
Document Outline
- Cisco 7200 VXR Routers
- 1 Documentation and Resources
- 2 Prepare for Installation
- 3 Rack-Mount the Router
- Brackets Front-Mounted-Chassis Protrudes from the Rack
- Brackets Front-Mounted-Chassis Recessed in Rack
- NPE-G1 and NPE-G2 Rear Cable-Management Brackets on a Front-Mounted Router
- Brackets Rear-Mounted-Front Protrudes from the Rack
- Brackets Rear-Mounted-Front Recessed in the Rack
- NPE-G1 or NPE-G2 Rear Cable-Management Brackets on a Rear-Mounted Router
- NPE-G1 or NPE-G2 Optical Cable-Management Bracket
- Two-Post or Four-Post Rack Installation
- Install the Chassis Ground
- 4 Connect the Router to the Network
- 5 Start and Configure the Router
- Power Cable Connections
- Important NPE-G1 and NPE-G2 Information
- Start the System and Perform a Basic Configuration
- Perform a Basic Configuration Using the Setup Facility
- Configuration Information for the NPE-G1 or NPE-G2
- Configure an Auxiliary Port to Receive Console Port Messages for the NPE-G1 or NPE-G2
- Configure the Native Gigabit Ethernet Interfaces on the NPE-G1 or NPE-G2
- Change the Media Type of the Native Gigabit Ethernet SFP, GBIC, or RJ-45 Ports
- Configure the Interface Transmission and Speed Modes for the NPE-G1 or NPE-G2
- Debug the NPE-G1 or NPE-G2
- Reset the Interface on the NPE-G1 or NPE-G2
- Clear Counters on the NPE-G1 or NPE-G2
- Configure Interfaces
- Save the Running Configuration to NVRAM
- Check the Running Configuration Settings
- View Your System Configuration
- Perform Complex Configurations
- Replace or Recover a Lost Password
- 6 After Installation
- Replace the Network Processing Engine or Network Services Engine
- Replace the I/O Controller
- Replace the PC Card, Flash Memory Card, Flash Disk, CompactFlash Disk, or USB Token
- Replace the Gigabit Interface Converter
- Replace the SFP-NPE-G2
- Installing a USB Flash Memory Module or eToken-NPE-G2
- Replace a Port Adapter or Service Adapter
- Replace the Port Adapter Jacket Card
- Replace the Power Supply
- 7 Cisco Product Security Overview
- 8 Obtaining Technical Assistance