Compaq ProLiant Interconnect Switch - Manual (Page 189)

Upgrading Firmware by Means of the Serial Port
Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide F-5
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 10:17 AM
11. While the GbE Interconnect Switch is in the download mode, change the baud rate of the
HyperTerminal session to match the baud rate of the GbE Interconnect Switch shown in
the display window. (The default is 115200, which is the fastest. If you need to change
the baud rate of the GbE Interconnect Switch, refer to steps 5 through 9 for instructions.)
To change the baud rate:
a. Disconnect the HyperTerminal session by selecting Call from the Interconnect
Switch – HyperTerminal window menu, and then selecting Disconnect.
b. From the Interconnect Switch – HyperTerminal window menu, select File then
Properties.
c. Click Configure.
d. Make the necessary changes to the baud rate and click OK.
e. After connecting HyperTerminal, a connection established message is displayed, as
shown in Figure F-4.
IMPORTANT: If the following screen displays unusual characters, this indicates a mismatched
baud rate configuration somewhere in the network. Check HyperTerminal to determine if the baud
rate setting on the GbE Interconnect Switch console interface and the HyperTerminal are
mismatched.
Figure F-4: Connection established message screen