Compaq ProLiant Interconnect Switch - Manual (Page 59)

Configuring the GbE Interconnect Switch Using the Console Management Interface
Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide 3-23
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 9:59 AM
Configuring Static Unicast Filtering Table
To configure the Static Unicast Table:
1. Highlight Configure Static Unicast Table on the Configure Static
(Destination-Address Filtering) Table menu.
2. Press the Enter key. The following screen is displayed.
3. Toggle the Action field between Add/Modify and Delete.
4. Type the VID in the VLAN ID field.
5. Type the MAC address to be statically entered in the forwarding table in the MAC
Address field.
6. Toggle the Type field to Permanent or DeleteOnReset, to set the unicast filter type.
7. Type the port number in the Allow to Go Port field.
8. Highlight APPLY and press the Enter key.
NOTE: To save the configuration settings permanently, you must enter them into NVRAM using
the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier in this
chapter.