Compaq ProLiant Interconnect Switch - Manual (Page 62)

Configuring the GbE Interconnect Switch Using the Console Management Interface
3-26 Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 9:59 AM
Configuring Static VLAN Entry
To create an 802.1Q VLAN:
1. Highlight Configure Static VLAN Entry on the IEEE 802.1Q VLANs
Configuration menu.
2. Press the Enter key. The following screen is displayed.
3. Type a VLAN ID number in the VID field.
4. Type a name for the new VLAN in the VLAN Name field.
5. Set the 802.1Q VLAN membership for each port by highlighting the Egress/Forbidden
field using the arrow keys, and then toggling between E, F, and the dash (—) using the
spacebar.
— E (Egress Member)—Specifies the port as being a static member of the VLAN.
Egress Member Ports are ports that will be transmitting traffic for the VLAN. These
ports can be either tagged or untagged.
— F (Forbidden Nonmember)—Defines the port as not being a member and also forbids
the port from joining a VLAN dynamically.
— — (Nonmember)—Specifies the port as not being a member of the VLAN, but the
port can become a member of the VLAN dynamically.