Performing a ping test, Rebooting the gbe interconnect switch, Performing a ping test -58 – Compaq ProLiant Interconnect Switch User Manual
Page 94: Rebooting the gbe interconnect switch -58
Configuring the GbE Interconnect Switch Using the Console Management Interface
3-58
Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 9:59 AM
Performing a Ping Test
To test the connection with another network device using Ping:
1. Highlight
Ping Test on the Switch Utilities menu.
2. Press
the
Enter key. The following screen is displayed.
3. Type the IP address of the network device to be pinged in the IP Address field.
4. Type the number of test packets to be sent (three is usually enough) in the Number of
Repetitions field.
5. Highlight
START and press the Enter key.
NOTE: To save the configuration settings permanently, you must enter them into NVRAM using
the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier in this
chapter.
Rebooting the GbE Interconnect Switch
The GbE Interconnect Switch reboot options are:
• Reboot—Restarts the GbE Interconnect Switch. Any configuration settings not saved
using Save Changes from the main menu are lost. The GbE Interconnect Switch
configuration is restored to the last configuration saved in NVRAM.
• Save Configuration & Reboot—Saves the configuration to NVRAM (identical to using
Save Changes) and then restarts the GbE Interconnect Switch.