FXpansion GURU - Manual (Page 28)

27
3:1 Pad Edit view
When you click the Pad Edit button on the GURU toolbar, the
Edit button just above the Pad display, or the Pad Edit toggle
button in the Pattern view, the Pad Edit view appears in the
GURU LCD. This view allows you to adjust the various settings
for the last Pad selected via the onscreen Pad buttons.
You can exit the Pad Edit view by clicking the large OK button
or the Pad Edit toggle button in the Utility controls section.
You can quickly jump to the Pad Edit settings for any other Pad
by clicking the relevant Pad on the screen.
Each layer in each Pad has its own Pad Edit settings.
Pad Edit Keyboard modifiers
• If you hold down the [ALT] key on your computer keyboard
while adjusting any parameter control in the Pad Edit view
(with the exception of the start and end markers in the wave-
form display, and the Velocity split display), the parameter will
be adjusted to the same value for all Pads (and each layer
within them) in the current Engine.
• You can also [CTRL]-click in order to reset a parameter to its
default value (again, this does not apply to the start/end mark-
ers or the velocity split display).
• It logically follows that you can click a control while holding
down [CTRL] and [ALT] in order to reset that control on all lay-
ers to defaults.
Please refer to section 11:2 for a full list of Pad Edit view key-
board modifiers.
The behaviour of the [ALT] key
in the Pad Edit view can be
altered via the Options panel,
using the ‘[Alt] key in Pad Edit
links only current Pad layers’
option.
This results in [ALT]-key edits
affecting all layers on the cur-
rent PAD, rather than layers in
all Pads in the current Engine.
Direct/Aux controls
Utility controls
Layer/Velocity split controls
OK (exit) Insert slot Audition
Gain, pan & filter controls
Amp & FX Envelopes
Waveform display
Pad edit button
Pad edit toggle