GTCO Super L III - Users Guide - Manual (Page 10)

Super L III 10
Mounting Transducer Holders
Each transducer comes with a holder. Remove the protective paper, exposing the adhesive
layer on the bottom of the holder. Place the holder in a convenient location on the tablet,
outside the marked active area.
Using the SuperSet Menu
Configuring for Specific Application Programs
To Configure Super L III for Use with Specific Application Programs:
1. In Table 1, select the application program you will be using with Super L III. Note the
corresponding SuperSet Code.
a. If your application program is not listed in Table 1, find the configuration
settings that apply to your application program in Table 2 and use that
SuperSet Code.
b. If an appropriate SuperSet Code is not listed in Table 2, then use the Tablet
Configuration Utilities to set up Super L III.
2. Select the S block on the SuperSet Menu. This lets the Super L III know you are
about to set a new configuration. You will hear one short beep.
NOTE: The proximity light will turn on only when the transducer is over a SuperSet Menu
block that is a valid selection (for example, the proximity light will not turn on over a digit
block until the S block has been selected).
3. On the SuperSet Menu, select the two digits of the SuperSet code for your
application program. You will hear one short beep after the first digit. Then,
following the second digit, you will hear the four short “Success!” tones informing
you that Super L III has reset itself to the new configuration. The proximity light on
the tablet will also flash four times.