GTCO Super L III - Users Guide - Manual (Page 26)

Super L III 26
Resetting Super L III
There are four ways to reset Super L III:
 Enter SuperSet code 00 on the SuperSet Menu
 Turn the power switch off and back on
 Unplug and re-plug power supply
 Send remote commands described in the Advanced Operating Information section
When one of these events occurs, the Super L III will revert to the configuration that was
last defined. Any remote commands that were active before the reset will be lost.
Tablet Power/Proximity LED
The tablet led will be on when the tablet is on and transducer is awake and in the active
area.
Super L III Tones
Super L III produces an “alarm” in the form of audio tones to notify users of various events.
The table below describes the kinds of tones you may hear while operating the digitizer.