GTCO Super L III - Users Guide - Manual (Page 66)

Super L III 66
Table 13: Rate Commands
Point Mode
In Point Mode, one coordinate is sent when a transducer button is pressed. Output occurs
only when the transducer is in the active area.
To select Point Mode:
Tablet Configuration Utilities:
GTCO Commands:
Select the Point option under Mode.
Send command PT.
Line Mode
In Line Mode, coordinates are sent as long as a transducer button is pressed. Output
occurs only when the transducer is in the active area.
To select Line Mode:
Tablet Configuration Utilities:
GTCO Commands: Select Line Mode.
Send command LN.
To set the rate at which coordinates are sent in Line Mode:
Tablet Configuration Utilities:
GTCO Commands:
Select 12, 50 or 100 under Rate.
Send command Rx (where x = 1-6), as
shown in Table 13.