GTCO Super L III - Users Guide - Manual (Page 25)

Super L III 25
Controlling the Alarm
There are five ways to toggle the alarm on or off and set the tone:
 Select the SuperSet Menu Alarm block (which toggles the alarm tone on and off).
 Use the following remote commands.
Controlling the Alarm Using Remote Commands
An alarm (audio tone) is provided so Super L III can inform you of certain conditions. The
alarm can be enabled or disabled by the SuperSet Menu or commands.
To hear only critical tones, turn the alarm off:
SuperSet Menu:
GTCO Commands: Select the Alarm menu block – the fat left block showing a
speaker. Three medium length tones will be heard when
digitized.
Send command AD.
To hear all tones, turn the alarm on:
SuperSet Menu:
GTCO Commands: Select the Alarm menu block. Three medium length tones will
be heard when digitized. Then, a tone will be heard each time
a transducer button is pressed.
Send command AE.
When you move the cursor over the Alarm block on the SuperSet Menu, the Proximity
indicator (
green ) will light if the alarm is currently enabled.