GTCO Super L III - Users Guide User Manual
Page 68
Super L III 68
Continuous Incremental Mode
In Continuous Incremental Mode, one coordinate is sent when the transducer is moved
farther than a preset increment or a transducer button is pressed or released. Default
increment is 0.01”. Output occurs only when the transducer is in the active area.
To select Continuous Incremental Mode:
Tablet Configuration Utilities:
GTCO Commands:
Select the “Cont Incr” option under Mode.
Send command CL; to set a new increment
value, send command IV and at the prompt,
send three digits representing the new
increment in units of 0.001”.
Remote Request Mode
In Remote Request Mode, one coordinate is sent when the Controller receives a Read
Current Coordinate command (CTRL-B).
To select Remote Request Mode:
Tablet Configuration Utilities:
GTCO Commands:
Not available.
Send command RM.
Controlling the Alarm Using Remote Commands
An alarm (audio tone) is provided so the Super L III can inform you of certain conditions.
The alarm can be enabled or disabled by the SuperSet Menu or commands.
To hear only critical tones, turn the alarm off:
SuperSet Menu:
GTCO Commands:
Select the Alarm menu block
Send command AD.