GTCO Super L III - Users Guide - Manual (Page 5)

Super L III 5
Standard Operating Information
Parts Checklist
 Super L III Series digitizer with
attached Controller
 Transducer (cursor or stylus)
 Power supply
 Computer interface cable with 9-pin
connector and 9 to 25 adapter
 TabletWorks CD, which includes an
electronic User’s Manual
NOTE: Super L III Controller is the small enclosure attached to the back of the tablet. The
Controller contains the electronics that drive the digitizer.
What You Need to Use Super L III
 Computer with an RS-232C communication port
 Graphic application software that accepts digitizer input
Caring for the Tablet and Transducer
Follow these precautions at all times to avoid damaging your Super L III:
 Avoid discharging static electricity to the tablet.
 Do not place heavy objects on the tablet surface.
 Do not use sharp objects; such as compasses or knives, on the tablet surface.
 Do not use the tablet surface for any purpose other than drawing, tracing or
digitizing.
 Do not drill holes on any part of the digitizer or controller.
Cleaning the Tablet
To clean the tablet’s surface, use a soft, non-abrasive cloth. Hardened dirt can be removed
with a slightly dampened cloth. Do not clean pencil lines with a soft cleanser or pencil
eraser. This could create an undesirable shiny spot on the tablet’s surface that cannot be
removed.