GTCO Super L III - Users Guide - Manual (Page 65)

Super L III 65
Digitizing Modes
Digitizing mode refers to the method Super L III uses to determine when to output a
coordinate format. Six digitizing modes are available, but only one can be used at a time:
 Point Mode
 Line Mode (sometimes called Switched Stream Mode)
 Continuous Mode (sometimes called Stream Mode)
 Line Incremental Mode
 Continuous Incremental Mode
 Remote Request Mode
Table 14 will help you compare digitizing modes.
Table 14: Results of Active Area and Pushbutton Changes in Digitizing Modes