GTCO QuikRuler III - Users Guide - Manual (Page 10)

QuikRuler III 10
QuikRuler Menu Location
When QuikRuler III is shipped to you, it is programmed to expect the QuikRuler Menu to be
located in the lower left corner of the digitizer’s active area.
Relocating the Menu at Start-Up
When you start QuikRuler III, the below message appears for five seconds.
If you do not want the QuikRuler Menu to be positioned in the lower left corner of the
digitizer, this is the time to relocate it.
1. Position the menu where you prefer to have it located and tape it down. The entire
menu must be within the digitizer’s active measuring area.