GTCO QuikRuler III - Users Guide - Manual (Page 12)

QuikRuler III 12
4. Click the stylus on the left point of the menu. The Select from Menu prompt
displays to indicate the QuikRuler Menu relocation has been successful.
If You Lose the Menu Location
If you inadvertently move the QuikRuler Menu, please follow the below instructions:
1. Tape the menu down where you want it to be located.
2. Disconnect the digitizer power supply.
3. Reconnect the digitizer power supply and listen for the digitizer’s four beeps.
4. When QuikRuler III displays the below message, click the stylus anywhere on the
digitizer’s active area to enter Relocate Mode.
5. Follow the prompts to select Point 1 and Point 2. (See the previous page for an
illustration of the left and right menu points, Point 1 and Point 2.)
The Select from Menu prompt displays to indicate the QuikRuler Menu relocation
has been successful.
Using the Configure Function
QuikRuler III provides a number of user preference settings. Use the Configure button to
set:
 Number of digits to the right of the decimal point
 Tones you want to hear when you perform specific functions
 Language preference
 Character selections
The steps below describe how to select a specific configuration preference. The sections
that follow describe how to select a setting for each configuration preference.
1. Select the button to activate the Configure function.
QuikRuler III displays a preference option and its current setting.