GTCO QuikRuler III - Users Guide - Manual (Page 33)

QuikRuler III 33
Scale to convert: 3/16”=1’
Make both sides the same unit of measure (inches): 3/16” = 12”
Multiply both sides by the denominator (16) to eliminate the fraction:
3/16*16 = 12*16 Result: 3 = 192
Divide both sides by the numerator (3) to get the ratio: 3/3 = 192/3 = 64”
Divide the value by the number of inches in a foot (12) to convert the value to feet: 64/12 =
5.33
So, in 3/16” scale, 1 inch is equal to 5.33 feet.
Appendix C: Regulatory Statements and Warranty
Radio Frequency Energy Notice
This equipment has been tested and found to comply with the limits of a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee the interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
 Reorient or coil cables.
 Consult the dealer or an experienced Radio/TV technician for help.
NOTE: Any cables the user adds to the device must be shielded to be in compliance with
the FCC standards. Any unauthorized modification to this device could result in the
revocation of the end user’s authority to operate this device.