GTCO QuikRuler III - Users Guide - Manual (Page 23)

QuikRuler III 23
1. Measure the entire area, as described in the previous sections.
2. Click on the or button to indicate an area is going to be added or
subtracted, respectively.
3. Measure the area to be added to, or subtracted from, the first area.
4. If necessary, repeat the previous two steps to add or subtract additional areas.
5. Click on the button to calculate the total.
Measuring the Length of a Perimeter
QuikRuler can instantly calculate the length of an area’s perimeter.
1. After measuring an area, click on the button to display the length of the
area’s perimeter.
NOTE: Only the perimeter of the most recently measured area is displayed. Perimeters of
multiple areas are not summed unless the areas are measured in Perimeter Mode.
Counting Drawing Elements
Use the function to count the elements of your drawing, such as rooms, or
walls, or electrical outlets. You can count at any time, even while you are using another
function. Use the function to set the counting scale.
1. Click on the gray button on your stylus if you want to increment the current count in
the background while you are using another function.
OR