GTCO QuikRuler III - Users Guide - Manual (Page 15)

QuikRuler III 15
2. Click on the or button to move the cursor to the character you want to
use.
3. Select the button to save your setting, or choose another configuration option
or QuikRuler function to save your setting or activate the selected function.
Setting the Last Output Character
When a numeric value is present on line 2 of the display and the button is clicked,
the value is sent to the computer. You can use this option to specify which character you
want to use to indicate the end of the numeric value being sent. Your selection may be
predicated on the destination of the data. For example, you may want to choose the Tab
character as the Last Character if you are sending data to an Excel spreadsheet. The tab
character will move the cursor to the next cell, where it will be ready to receive the next
numeric value.
1. Display the Last Character option is shown on line 1.
The currently selected last character is displayed on line 2.
2. Click on the or button until you see the last character you want to use.
You can choose from the following terminator characters:
 Enter
 Tab
 Down Arrow <↓>
 Right Arrow <→>
3. Select the button to save your setting, or choose another configuration option
or QuikRuler function to save your setting or activate the selected function.