GTCO QuikRuler III - Users Guide - Manual (Page 30)

QuikRuler III 30
Messages
QuikRuler III displays a variety of messages as you use its functions. Most of the messages
are indicative of normal operation, such as prompts that instruct you how to perform the
next step in a process. Other messages can signal a problem.
Message Meaning
**No Digitizer** QuikRuler III is not attached to the digitizer. You must
attach it before you can proceed. See instructions for
Connecting the Components.
**Memory Failure** The power on test detected a memory failure. QuikRuler
III will attempt to continue normally with all operations, if
you click the stylus tip or cursor anywhere on the digitizer
surface.
**Bad Ref Point** This message will appear during a Relocate Menu
operation when an incorrect lower left or lower right
reference point is entered. Make sure that the entire
QuikRuler Menu is within the digitizer’s measuring area.
Repeat the Relocate Menu operation when this message
appears.
**Menu Off Tablet** This message will appear during a Relocate Menu
operation when the QuikRuler Menu is not positioned
entirely within the digitizer’s measuring area. Move the
menu and repeat the Relocate Menu operation when this
message appears.
**Number Too Big** The number on line 2 of the display is too large for
QuikRuler III. Try changing units to reduce the number
size when this message appears.
If you receive any of these messages and the above suggestions do not correct the
problem, contact the GTCO CalComp by Turning Technologies Technical Support Team.