GTCO Surface-Lit AccuTab - Users Guide - Manual (Page 10)

Surface-Lit AccuTab 10
6. Install the new bulb with its aperture facing toward the center of the tablet (see
figure in Step 4). (The aperture is the 1/4” wide clear window that runs the length of
the bulb.) Press down on each end of the bulb until it snaps into place and until the
bulb makes contact with the adhesive on the heat sink.
7. Replace the upper extrusion. Make sure that the ends of the upper extrusion align
with the ends of the lower extrusion.
8. Discharge the upper corner blocks. Do not over tighten the screws.
Configuring Your Computer
Apply power to the computer. Configure the graphic application software to operate with
AccuTab. Many application programs provide configuration information for specific
digitizers. If the GTCO CalComp by Turning Technologies AccuTab digitizer is not listed, you
can use the configuration for GTCO CalComp by Turning Technologies Digi-Pad Type 5 or
Type 5A (T5/T5A), CalComp 9100/9500 or Summagraphics Microgrid III.
If necessary, install the appropriate digitizer driver(s) from the Digitizer Driver CD supplied
(AutoCAD, Windows and mouse drivers are included). Insert the diskette into drive A or B.
From the DOS prompt, type a:\install or b:\install and then follow the onscreen
instructions.
NOTE: Install only the drivers that are necessary for the AccuTab to work with your
application software.
Mounting Transducer Holders
Each transducer comes with a holder. Remove the protective paper, exposing the adhesive
layer on the bottom of the holder. Place the holder in a convenient location on the tablet,
outside the marked active area.