GTCO Surface-Lit AccuTab - Users Guide - Manual (Page 21)

Surface-Lit AccuTab 21
Resetting AccuTab
There are four ways to reset AccuTab:
 Enter AccuSet code 00 on the AccuSet Menu.
 Press the reset button on the rear panel of the Controller.
 Turn power off and on.
 Send remote commands described in the Advanced Operating Information section.
When one of these events occurs, AccuTab will revert to the configuration that was last
defined. Any remote commands that were active before the result will be lost.
Controlling the Illuminated Cursor Lamps
To toggle the Illuminated Cursor’s lamps on or off:
 Select the block on the AccuSet Menu.
 Lamps will automatically turn off if the cursor remains motionless for about 15
minutes. To turn the lamps on again, just move the cursor.
Transducer Lights
Different transducers have a variety of indicator lights on them. This section describes
what the indicators notify about the operation of the AccuTab.
 Proximity Indicator ( red ): Standard on all transducers and is on when the transducer
is within the tablet’s active area. Conversely, it is off when the transducer is outside
the active area. Under most conditions, the AccuTab will not generate coordinate
formats when the transducer is outside the active area.
This indicator is also used to communicate status information to you when you’re using
the Custom Configuration Menu or AccuSet Menu.
 Point/Line Indicator ( green ): Available on the 16-button cursor only and tells you
which digitizing mode is in use. If Point Mode is active, the light is off. If Line Mode
or Continuous Mode is active, the light is on.
 Status Indicator ( yellow ): Available on the 16-button cursor only (not available on
the Illuminated Cursor). This indicator is controlled by remote commands.
Application programs can turn the status indicator on and off by sending the
appropriate commands.