GTCO Surface-Lit AccuTab - Users Guide - Manual (Page 17)

Surface-Lit AccuTab 17
To configure AccuTab with the Custom Configuration Menu:
1. Place the Custom Configuration Menu card (included with the system) in the active
area of the tablet. The entire menu must be in the active area. (Hold the menu in
place to keep it from moving during the configuration process.)
2. Select the menu block at the right end of the AccuSet Menu. The proximity light
on the transducer will flash slowly, indicating that the Custom Configuration Menu
mode is now ready to receive Alignment Point 1.
3. You must notify the Controller where the Custom Configuration Menu card is
located on the tablet. Select Alignment Point 1 (small blue square) in the lower left
corner of the card. The proximity light on the transducer will flash rapidly, indicating
that the system is waiting to receive Alignment Point 2.
4. Choose Alignment Point 2 (small blue square) in the lower right corner of the card.
The LED will only light up if passed over an active menu block on the Custom
Configuration Menu (or is moved off the menu card into the active area of the
tablet).
If the invalid alignment points are selected or if the Custom Configuration Menu is not
entirely in the active area, the menu mode will be aborted. This is indicated by three long
beeps from the alarm and three long flashes from the proximity light on the transducer.
5. Configure the AccuTab by selecting the function blocks that correspond to the
settings you want.
6. Review the configuration to ensure that the proper settings have been selected.
Pass the transducer down each group of options; the proximity light will turn on
when the transducer is over the active choice.
7. After making the selections, two options are presented: 1) save as a temporary
configuration or 2) save the configuration in a user-definable location for later recall.
 To Save the Configuration Temporarily: Select on the AccuSet Menu.
You will hear four “Success!” tones and see four proximity light flashes when
you successfully save a configuration. The configuration is saved in a
temporary location, where it will be retained even if the unit is powered off