GTCO Surface-Lit AccuTab - Users Guide User Manual
Page 20
Surface-Lit AccuTab 20
Mode Options
Mode: Defines how output reports are sent from the digitizer. Choices are: Point,
Line, Continuous, Line Incremental or Continuous Incremental.
Rate: Determines how fast output reports will be transmitted from the digitizer.
Choices are: 12, 50 or 100 reports per second.
Resolution: The smallest reported value returned by the digitizer. Choices are:
1000 lpi, 2000 lpi, 4000 lpi, 40 lpmm, 100 lpmm or 150 lpmm.
Controlling the Alarm
There are two ways to toggle the alarm on or off:
Select the
block on the AccuSet Menu.
Use the below remote commands.
Controlling the Alarm Using Remote Commands
An alarm (audio tone) is provided so AccuTab can inform you of certain conditions. The
alarm can be enabled or disabled by the AccuSet Menu or commands.
To hear only critical tones, turn the alarm off:
AccuSet Menu:
Select the
menu block
GTCO Commands:
Send command AD.
To hear all tones, turn the alarm on:
AccuSet Menu:
Select the
menu block
GTCO Commands:
Send command AE.
When you move the cursor over the
block on the AccuSet Menu, the Proximity
indicator (
red
) will light if the alarm is currently enabled.