Corinex Global ADSL2+ - Manual (Page 15)

14
Installation Overview
Corinex ADSL2+ Wireless Gateway G
3.1.2 Connecting to the ADSL Line
To connect the gateway to the ADSL line, please use the supplied telephone cable
(RJ11). Plug one end of the cable to the DSL port of the gateway, and plug the other
end of the telephone cable into the telephone socket in the wall. If you want to plug
a phone in at the same location, you will need to use a POTS splitter.
A POTS Splitter (with built-in Microfilter) is a device that allows you to connect both
your telephone cable and telephone set to the same wall socket. At the same time,
this splitter helps to eliminate background noise on the telephone line, ensuring the
best possible phone performance.
3.1.3 Connecting to the Power Outlet and Powering On
1. Connect the supplied power supply cable to the DC 9V port on the gateway.
2. Plug the power adapter into the electrical outlet.
3. Power on the gateway by toggling the POWER switch into position I.
4. Start up all computers in the network.
3.2 Configuring Your Ethernet Network Card / Installing Your
USB Device
If your computers are connected to the Ethernet Port of the gateway, proceed with
section 3.2.1. If your computer is connected to the gateway’s USB Port, you can
skip ahead to section 3.2.2.
3.2.1 Configuring Your Ethernet Network Card
Proceed with this section ONLY if your computer is connected to the Ethernet Port
of the gateway.
The following instructions are based on the Windows XP operating system. The
configuration procedure may be slightly different on other operating systems. Please
refer to the documentation of your operation system for more information about
establishing a network connection.
(Instructions are based on default Start menu option)