Corinex Global ADSL2+ - Manual (Page 83)

82
Corinex ADSL+ Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G
Every device that connects to the modem has its own class identifier. A set top box
also has its own identifier. Whenever the set top box connects to the Gateway, it
will send a DHCP discovery. The Gateway will check the DHCP option 60 in the
packet. If the option 60 identifier matches the identifier stored in the Gateway,
the Gateway will remember the MAC address of the STB. All incoming LAN
traffic with the source MAC address matching the MAC address stored in the
Gateway will be directly sent to the ISP. All incoming traffic from the ISP going to
the destination MAC address stored in the Gateway will be sent directly to STB
without any routing.
Only one PVC and one MAC address is supported at the moment.
Note: You must not enter your PC’s identifier (MSFT 5.0) into the class
identifier field. If you do so, your PC will not be able to get access to any
webpage anymore.
4.4.20 Simultaneous Bridge & Route
Enabling this option will allow that special devices like set top boxes (STB) will get a
public address from the ISP and send/receive packets directly from the ISP without
being routed.