Corinex Global ADSL2+ - Manual (Page 87)

The table below describes the options in this page:
Option Description
Enable AP The wireless setup allows the user to enable or disable
the AP (access point). Disabling of AP will prevent
the Gateway from emitting or receiving any wireless
signal.
SSID Here you can enter your SSID which is an identification
string for your wireless access point
Hidden SSID If this field is checked, the access point will not send the
SSID to other wireless enabled devices in the range.
Channel B/G You can select the channel for transmission of the
wireless access point. Please note that not all channels
are allowed in each country. Refer to the following
regulation information (IEEE STD 802.11b-1999/Cor
1-2001):
- Europe: channels 1-13
- USA/Canada : channels 1-11
- Japan: channels 1-14
- Spain: channels 10 &11
802.11 Mode You can select the mode so that only selected wireless
devices can connect to your access point:
- Mixed: both 802.11b and 802.11g devices can
connect
- B only : only 802.11b devices can connect
- B+: both devices with 802.11b and enhanced
802.11b+ (22 Mbps) can connect
- G only : only 802.11g devices can connect
4x If this is checked, the access point switches to the
enhanced 44 Mbps throughput rate. This mode is
backwards compatible with 802.11b
86
Corinex ADSL2+ Wireless Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G