Corinex Global ADSL2+ - Manual (Page 32)

31
Corinex ADSL2+ Wireless Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G
4.3.4 Firewall / NAT Services
For the LAN interfaces, Firewall and NAT are enabled by default. If you don’t want
to use Firewall or Network Address Translation, you can disable it in the screen
below.
4.3.5 WAN Setup
Before the gateway will pass any data between the LAN interface(s) and the WAN
interface, the WAN side of the modem must be configured. Depending upon your
DSL service provider or your ISP (internet service provider), you will need some (or
all) of the information outlined below before you can properly configure the WAN:
• Your DSL line VPI and VCI
• Your DSL encapsulation type and multiplexing
• Your DSL training mode (default is MMODE)
For PPPoA or PPPoE users, you also need these values from your ISP:
• Your username and password
For RFC 1483 users, you may need these values from your ISP:
• Your DSL fixed Internet IP address
• Your Subnet Mask
• Your
Default Gateway
• Your primary DNS IP address