Corinex Global ADSL2+ - Manual (Page 99)

98
Corinex ADSL2+ Wireless Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G
Press one of the buttons to execute a system command. The commands are
described in the following table.
Field Description
Save All Press this button in order to permanently save the current
configuration of the Gateway. If you do restart the system
without saving your configuration, the Gateway will revert
back to the previously saved configuration.
Restart Use this button to restart the system. If you have not saved
your configurations, the Gateway will revert back to the
previously saved configuration upon restarting.
NOTE: Connectivity to the unit will be lost. You can re-
connect after the unit reboots.
Restart Access
Point Use this button to restart the Wireless Access Point. It is
important to Restart Access Point any time you change
your Wireless settings.
Restore Defaults Use this button to restore factory default configuration.
NOTE: Connectivity to the unit will be lost. You can re-
connect after the unit reboots
4.6.2 Remote Log
The Gateway is able to capture everything that happens during operation using the
Remote Log (or Syslog) function. The syslog protocol provides a transport to allow
a machine to send event notification messages across IP networks to event message
collectors - also known as syslog servers.