Corinex Global ADSL2+ - Manual (Page 45)

44
Corinex ADSL2+ Wireless Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G
2. At the Type field select DHCP.
The PPPoE connection setup page is displayed. The picture below illustrates a
typical DHCP configuration.
3. If your DSL line is connected and your DSL/ISP provider is supporting DHCP,
you can click the Renew button and the gateway will retrieve an IP address,
Subnet mask, and Gateway address. At anytime, you can release the DHCP
address by clicking on the Release button, and renew the DHCP address by
clicking on the Renew button.
4. Under PVC Settings, enter the values of VPI and VCI settings.
Note: Your DSL service provider or your ISP will supply these.
5. Select the quality of service (QOS); leave the default value if you are unsure or
the ISP did not provide this information.
6. Click the apply button to complete the connection setup. This will temporarily
save this connection.
7. To make the change permanent, click on Save all settings in the left menu.
8. For connection, click on Connect.