Novak Sentry Data Logger - Manual (Page 9)

9 Device Setup | Novak Electronics, Inc.
www.teamnovak.com
BATTERY VOLTAGE SENSOR
Sensor Description: The Battery Voltage Sensor is used to monitor the voltage of the main battery pack in an
electric vehicle.
Measurement Range: 0-20 volts
Resolution: 0.100 mV
Plugs Into: The 2-pin connector plugs into the Voltage Slot (VOLT) in
the Novak Sentry Data Logger unit with the black wire toward the
outside/left edge of the case.
Default Settings ( configurable setting ):

Graph Color:

Max Value (Gauge Display Only): 20 volts

Name String: Battery Voltage
Installation Instructions (refer to images shown right) :
 The RED wire should be soldered or connected to the positive
(+) terminal of the battery pack or speed control.
 The BLACK wire should be soldered or connected to the
negative (-) terminal of the battery or speed control.
Connect to Battery Terminal
Connect to Speed Control Terminal
Replacement Part Number: Novak Kit # 5362
WARNING! Do not plug in this sensor backwards! Plugging in the voltage sensor backwards will cause
damage to your Novak Sentry Data Logger and void the product warranty .