Slant/Fin CHS-399 - Manual (Page 25)

CHS Series Controller and Display
│
Slant Fin Corp.
23
2.4.4.3 Statistics Config
Figure 2-21 Statistics Configuration Screen
Statistics Config – sub-menu screen displays the
number of burner and pump cycles, as well as burner
run time. Use the up and down (▲▼) buttons to
navigate the menu options; when the desired option is
highlighted select by pressing the “OK” button.
Pump cycle counts can be reset by the installer, for
example when a circulator is replaced.
Burner cycles and Burner run
time counters cannot be reset.
Table 2-15 Statistics Configuration Parameters
Parameter Description Factory Settings
Burner cycle
count Number of burner cycles on controller. Not resettable by the installer. Range 0 to
999,999.
0
Burner run time Total number of hours of burner operation. Range 0 to 999,999 hours. 0 hour
Boiler pump
cycle count *
Number of Boiler pump (Pump B) cycles since last reset. Range 0 to 999,999. 0
CH pump cycle
count *
Number of CH pump (Pump C) cycles since last reset. Range 0 to 999,999. 0
DHW pump
cycle count *
Number of DHW pump (Pump A) cycles since last reset. Range 0 to 999,999. 0
* = Password protected
Burner cycle count
Burner run time
Boiler pump cycle count
CH pump cycle count
DHW pump cycle count
29
7 hour
75
56
74
Statistics Config