Toa DP-K1 - Manual (Page 18)

18
5.2. Deleting the Unit
The unit configuration that has been already created can be changed only when the PC is not in
communication with the unit.
Select the unit to be deleted in the unit view or flow view.
Select [Unit
Delete] from the menu to display a dialog for confirmation.
Pressing the OK button deletes the unit.
5.3. Changing the Unit Configurations
The unit configuration that has been already created can be changed only when the PC is not in
communication with the unit.
Select the unit for which you want to change the unit configuration in the unit view or flow view.
Select [Unit
Change Unit Configuration] from the menu to display the unit setting screen. Unit configuration
can be changed in the same procedures as for creating a new unit configuration.
5.4. Changing the Zone Settings
You can change the configuration zone settings already created.
Select the unit for which you want to change the zone setting in the unit view or flow view.
Select [Unit
Zone] from the menu to display the Zone Setting screen.
Zone settings can be changed in the same procedures as for creating a new Unit configuration.
5.5. Changing the Crossover Combinations
You can change the configuration crossover combinations already created.
Select the unit for which you want to change the crossover combination in the unit view or flow view.
Select [Unit
Change X-over Combination...] from the menu to display the Crossover Combination
screen.
Crossover combination settings can be changed in the same procedures as for creating a new Unit
configuration.
5.6. Changing the Crossover Slopes
You can change the configuration crossover slopes already created.
Select the unit for which you want to change the crossover slopes in the unit view or flow view.
Select [Unit
Change X-over Slope...] from the menu to display the Crossover Slope screen.
Crossover slope settings can be changed in the same procedures as for creating a new Unit configuration.