Toa DP-K1 - Manual (Page 64)

64
Step 2. Change the unit's network setting
(1) Select the unit for which you want to change the
network setting, then press the [Modify IP Setting]
button.
The IP Setting screen is displayed.
(2) Set the IP address, then press the OK button.
Only when controlling the DP-K1 via router, default gateway edit may be required.
Marking the [Enable edit of the "Default Gateway"] checkbox enables default gateway setting.
The message at right is displayed when
marking the checkbox.
Press the [Yes] button, then set the default
gateway.
(3) Press the [Send Modified Settings] button.
Setting changes are uploaded to all the units for
which network settings have been changed on the
software.
Note
In this state, the unit's network setting has not been changed.
To change the IP settings of the multiple units, perform Steps (1) and (2) above to all the units for
which you want to change the settings, then advance to Step (3) below.