Toa DP-K1 - Manual (Page 36)

36
Note
The screen below appears when the Crossover function is set because the corresponding channels are
assigned to the same zone.
Note
Settings by way of the following fader and buttons can be made only in the Matrix View.
(1) Fader
If you select the Crosspoint set to on, the corresponding Fader is displayed.
You can change the signal level at the selected Crosspoint by moving this fader up or down.
(2) Level setting button [Level (dB)]
If you select the Crosspoint set to on, the corresponding Level setting
button [Level (dB)] is displayed.
Indicates the signal level at the selected Crosspoint by means of
numerical values.
If you press this button, a dialog for level setting is displayed, enabling
you to set the level by directly entering a numerical value.
Setting Range: –∞ to 0 dB
You can also change the level in 1 dB units with the UP and Down
buttons located on the right side.
(3) Reverse polarity button [Polarity]
Displays each channel's polarity. Pressing this button permits the polarity to be reversed.
(4) Numerical value indication button
Indicates the level setting at each Crosspoint by means of a numerical value if this button is pressed.
To return the screen to the graphic display, press this button again.